Product Overview — 3116342
Overview
Sensor 3116342 is a commonly used spare part in construction machinery. We can supply all the original and replacement part numbers listed below, in stock or available on order — welcome to enquire by part number.
Applicable Models & Applications
This sensor is used on Caterpillar machines, feeding the control system with the measured value at the rated output. Suitable for the corresponding machine model and configuration — please verify the machine model, serial number and part number match before ordering.
Maintenance & Replacement
Check sensors for correct output and clean connectors at service; replace when readings drift, the connector corrodes or the sensor wires chafe, and calibrate where the manual allows. Early signs it may need attention: A sensor that reads out of range or intermittently; A rough-running or derated machine caused by a bad feedback signal; Corrosion, bent pins or crushed wires on the sensor connector.
Installation Essentials
Confirm the part number against your machine model and serial number before ordering. Work on a clean machine, with the engine off and the relevant system depressurised or drained first. Fit new seals, gaskets or O-rings and torque every fastener to the manual's figure. After installation, run the machine and check for leaks, unusual noise or abnormal travel before returning it to service, and retighten where the manual calls for it after the first hours of operation.
Reference Price
The reference price for this Sensor (listed under 3116342) is approximately USD 10 – 30 per unit, depending on configuration, quantity and shipping destination. This is an estimate for planning purposes — please confirm current pricing and availability with our sales team before ordering.
Available Part Numbers
- 3116342
Also in the Sensor Series
Same-series, real numbers we also supply (always confirm fit and interchange against your machine): 278-5308
Racer Machinery is a dedicated construction-machinery parts supplier — we keep a complete range of Sensor in stock and verify it against your machine before dispatch. Tell us your part number and model and we will confirm fitment, price and lead time.
